This is the electric powered, radio controlled, park scale Dumas Pilatus Porter Airplane Kit. FEATURES: Construction: Laser cut balsa Wing: Two piece with center section, high mount placement Covering: Three sheets of white tissue Cowl: Vacuum molded plastic with molded in spinner, white in color Landing Gear: Preformed wire .062" (1.6mm) diameter with .032" (0.81mm) diameter tail wheel wire Wheels: Two 1.6" (40mm) diameter lightweight foam main wheels and one 0.75" (19mm) plastic tail wheel Windows: One sheet acetate with pattern in manual for all windows Rudder: Pull-pull style with horn and cables included INCLUDES: All required balsa, three sheets white tissue, cowl, one small decal sheet, three wheels, one acetate sheet, hardware, instruction manual and two full-size plan sheets REQUIRES: Electric Motor: GWS IPS-DX2BB-1XCS Motor and Gear Drive (GWSG2022) or MPI EPU-4 drive unit Radio: 3-channel with micro size receiver Servos: Two micro size for rudder and elevator Electronic Speed Control: 5A with BEC Battery: 7.4V 700mAh Lithium Polymer Propeller: 8x6 for electric application Finish For Covering: Butyrate dope such as Midwest Aerogloss, light- weight Mylar covering can also be used, see COMMENTS Building and field equipment SPECS: Length: 27" (68.6cm) Wingspan: 40" (101.6cm) Wing Area: 285 sq in (18.38 sq dm) Center of Gravity (CG): 1-5/8" (41mm) from the leading edge of the wing measured at the fuselage Control Throws: Elevator: up and down 5/8" (16mm) Rudder: left and right 3/8" (19mm) Airfoil: Flat bottom COMMENTS: Do not use Ultra Cote or MonoKote covering. It is too heavy and will shrink too much damaging the lightweight structures. jxs 8/01/05 ir/jxs