This is a Radio Controlled, Electric Powered, Elapor Foam Construction Multiplex Acro Master 3D Airplane Kit. For Intermediate to Advanced Modeler/Flyers. FEATURES: Molded, Elapor Foam fuselage parts, white in color Wings: Molded, Elapor foam construction, white in color Radio compartment: Elapor foam construction Cowling: Elapor foam construction Canopy: Elapor foam construction Landing gear: Pre-bent .10" (2.6mm) diameter wire Aileron Control: Dual Servo Wheel pants: Elapor foam construction, white in color Spinner cone: Elapor foam construction, white in color Hardware: .070" (1.75mm) diameter pushrods, plastic hinges, and other miscellaneous hardware Designed by Aerobatic Champion Martin Mueller Motor Mount: White plastic construction Wheels: Elapor foam construction with metal axle sleeve INCLUDES: Elapor foam airplane parts, pre-bent wire landing gear, 2" (51mm) diameter wheels, fiberglass wing spar, hardware package, elapor wheel pants and spinner cone, decals and illustrated instructions. REQUIRES: Motor and ESC : Multiplex Power Kit (MPUG3215), Includes Himax HC3516-1130 Brushless Motor and Multiplex MULTIcont BL-55 ESC Battery - 3 cell LiPo Charger - LiPo compatible Radio: 4-channel radio with micro receiver Servos: 2 16oz/in torque minimum for the ailerons 2 35oz/in torque minimum for rudder and elevator Servo Extension 12": 2 required for aileron servos - HCAM2100 Y-Harness: 1 required for aileron servos - HCAM2500 SPECS: Wingspan: 43" (1095mm) Wing Area: 557.27 sq in (36.6 sq dm) Weight: 32-36oz (907-1020g) Wing Loading: 8.19 oz/sq ft (25 g/sq dm) Length: 45.25" (1150mm) Airfoil: Fully-Symmetrical, mid-wing placement Center of Gravity: 4-3/4" (120mm) Back from the wing"s leading edge at the fuselage sides. Control Throws- Low Rate High Rate Ailerons: Up & Down 1-3/8" (35mm) 2-3/16" (60mm) Elevator: Up & Down 1-3/8" (35mm) 2-3/4" (70mm) Rudder: Right & Left 1-3/4" (45mm) 3-1/8" (80mm) COMMENTS: This model is NOT made of styrofoam and it is not possible to glue the material using white or epoxy glue. Medium CA glue used with an activator is the only method of gluing recommended by the manufacturer. kpm11/01/2006 ir/jxs Upd OA 3/13/2008