This is the glow powered radio controlled ready-to-run Traxxas Nitro Rustler 1/10 scale Stadium Race Truck. FEATURES: Chassis: T-6 aluminum anodized blue with fiber composite upper plate/ front brace Radio: Traxxas TQ AM radio system Engine: Traxxas 2.5 racing engine with EZ-Start electric starter, slide valve carb, two glow plugs, air filter and cylinder head protector, battery and charger for EZ-Start Exhaust: Composite tuned pipe with aluminum header Drive: Rear wheel with telescoping U-joint drive shafts Body: Pre-painted, pre-cut polycarbonate body Shocks: Four composite bodied oil-filled Slipper Clutch: Adjustable Suspension: 4-wheel independent Transmission: Ball bearing equipped, Magnum 281 Differential: Planetary gear with steel internal gears Fuel Tank: 2.5oz (75cc) with flip-top lid and primer bulb Brake: Composite disc type Spur Gear: Nylon, 70 tooth 32-pitch Wheels: Chrome 2.0" (51mm) wide, 2.8" (71mm) diameter five-split spoke Jato Tires: Front, ribbed 2.8" (71mm) inner diameter, 2" (51mm) wide Rear, Traxxas Alias 2.8" (71mm) inner diameter, 2" (51mm) wide Caster: Adjustable, caster/toe-in refers to the angle of the front suspension when viewed from the side of the car in relation to the chassis Camber: Adjustable, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle suspension when viewed from the side of the car in relation to thei chassis INCLUDES: Assembled Nitro Rustler with TRX-2.5 racing engine and glow plug, EZ-Start electric starter, painted body with rear wing, decals, AM radio system, tuned pipe, instruction sheet, extra glow plug, fuel bottle, tools, battery & charger REQUIRES: "AA" Batteries: 8 (4 for transmitter and 4 for receiver) Fuel: Car fuel with 10-15% nitromethane content Misc. Items: Building and track equipment SPECS: Length: 17-1/4" (438mm) Front Track: 12-1/2" (318mm) Rear Track: 12-3/8" (314mm) Weight: 60 ounces (1701g) without radio Height: 6" (152mm) Wheelbase: 11.3" (287mm) Fuel Capacity: 2.5 ounces (75cc) Engine: TRX 2.5 racing w/EZ Start System Gear ratio: Adjustable 8.43:1 to 12.64:1 Differential: Planetary gear Brake: Disc Chassis: Double-decker (bottom aluminum,top composite) Spur gear: Nylon, 70 tooth 32-pitch Clutch bell: 20 steel tooth Caster block: Front 30 degrees COMMENTS: For Replacement Ball Bearings use: Qty. Size Location Qty. Bearing Set 4 5x11mm Front Wheels 2 DTXC1547 4 5x11mm Rear Wheels 2 DTXC1547 6 5x11mm Transmission 3 DTXC1547 2 5x11mm Clutch Bell 1 DTXC1547 REPLACING EZ STARTER WITH STANDARD RECOIL STARTER To convert the EZ starting to a standard "pull starter", purchase part numbers TRAG5170, TRAP5211 one-way bearing, 4 3x8mm machine screws, take out the three bolts on the EZ-Starter, clip the wires on the EZ-Starter, and install recoil pullstart. GX12/2/11