This is the 2.4GHz Radio Controlled, Brushless Electric Powered TxR (Transmitter Ready) Sensei Foam Trainer Airplane from Flyzone. This is the Tx-R (Transmitter Ready) version that includes servos, an ESC and SLT receiver. With the AnyLink SLT 2.4GHz Radio Adapter (TACJ2000) (separate purchase) and the appropriate AnyLink cable with compatible aircraft transmitter 4-channels or higher may be used to fly this airplane. See http://www.tx-ready.com/anylink-chart.html for full transmitter compatibility chart. **Additional Technical Info Will Be Added When It Becomes Available.** FEATURES: Construction: Aero-Cell foam with "drop door" in fuselage to deploy a parachute or other creative payloads while in flight Wings: Two piece Aileron Control: Dual servo Tail Section: Attaches with one screw and features self-aligning stabilizer Motor: Brushless 1350Kv (FLZA6174) Electronic Speed Control: 30A brushless compatible Receiver: Tactic 2.4GHz SLT receiver Servos: Five micro Battery: 2100mAh 11.1V LiPo Battery Charger: GPMM3319, LiPo compatible with balancing capability AC/DC adapter and 12V cigarette lighter plug Landing Gear: Main, prebent aluminum 0.098" (2.5mm) thick Wheels: Three foam 2.5" (63.5mm) Propeller: 10x5 plastic Spinner: 1.75" (45mm) diameter black plastic Warranty: Flyzone guarantees this kit to be free from defects in both material and workmanship at the date of purchase. This warranty does not cover any component parts damaged by use or modification. INCLUDES: Sensei Foam Trainer Airplane with Motor ESC, five micro Servos, Prop, Spinner, Landing Gear, Receiver, Wheels, Instruction Manual, Battery and Charger REQUIRES: Tactic AnyLink SLT 2.4GHz Radio Adapter (TACJ2000) to adapt aircraft transmitter (the Futaba Square, TACM0001 and JR, Spektrum, TACM0002 are included with the AnyLink adapter) *Tactic 2.4GHz 4 or 6 channel transmitters do not require the AnyLink adapter Pliers and phillips screwdriver SPECS: Wingspan: 58" (1475mm) Wing Area: 566 sq in (36.5 sq dm) RTF Weight: 3.2lbs (1450g) Length: 48" (1220mm) Airfoil: Flat bottom Configuration: High wing Center of Gravity: Draw a mark 1/4" (7mm) back and 1/4" (7mm) forward from the front of the aileron servo cover. The plane should balance between these two marks. Control Throws: Elevator, Up/Down: 1/2" (15mm) Rudder, Right/Left: 5/8" (16mm) Ailerons, Up/Down: 1/2" (15mm) jxs 01/16/12 ir/jxs