Function and operating principle "MOTOTEC 4" Tribological composition "MOTOTEC 4" performs two actions: cleans the surface friction and activates the process of accession to them metal microparticles contained in the working oil. These particles form a kind of protective layer that: - It is more durable, compared to most parts of the metal surface; - Holds a denser layer of oil; The protective layer is formed as long as the temperature, pressure, vibration and other parameters will not come to an optimum state, then the process of forming the layer is automatically stopped. The composition has an effect in all engine systems: - in gas distribution mechanism - in the lash, in plugs of valves and other friction units; - in the cylinder-piston group; - a crank mechanism - in particular in the bearing of the crankshaft; If the transmission is in a oil bath with the engine, the composition will process its details: surface gears and bearings. The composition has no effect on the clutch and the clutches does not change their characteristics as they are made of composite materials. Instructions for use "MOTOTEC 4" Composition "MOTOTES 4" is added to the working oil on the engine the following procedure: - Warm up the engine to operating temperature - Stop the engine. - Stir the vial with the composition so that the sediment at the bottom distributed throughout the liquid volume. - Fill the engine oil filler composition in the hole: If the engine capacity less than 500 cm3 - half the bottle. If the engine capacity of over 500 cm3 - a vial. - Immediately after making the composition start the engine. - Take a trip lasting 15-20 minutes in normal driving mode. Complete engine treatment is carried out as follows: Stage 1: Mileage 300-400 km. Changing the oil and oil filter Stage 2: Mileage 1000 km for the complete processing engine. Regular operation