MIL907312 Features: -Price Is For One Each -Minimum Order Of 1.-The Millermatic 180 has more output! This semiautomatic constant voltage wire welding package is capable of welding 24 gauge up to 5/16"" mild steel..-UNSPC CODE: 23271400.-Smooth-Start patent-pending technology provides a smooth, spatterfree start. It"s the best-starting machine in the small MIG machine category. No pop gun starts and no spatter to clean up. Infinite Voltage Control with Manual On/Off Wire Feed Speed Tracking provides a broader operating range with finer control by automatically increasing or decreasing wire feed speed when voltage is adjusted (unit shipped with wire feed speed tracking set to off ). Durable cast aluminum feedhead incorporates dual groove quick-change drive rolls and spring-loaded tension arm with calibrated tension knob all designed to make set up easier and faster. Miller"s exclusive ""Tip Saver"" short circuit protection shuts down output when tip is shorted to the work. Extends contact tip life and protects internal components from damage. Trigger reset permits quick reset at torch rather than unit. Thermal Overload Protection - Internal components are protected from damage by thermal overload protection which automatically shuts down the unit if duty cycle is exceeded or air flow and cooling are restricted. Standard built-in contactor makes wire electrically ""cold"" until trigger is pulled. Makes unit safer and easier to position torch to work before starting weld. Self-resetting motor protection circuit eliminates the need to find and replace fuses. Uses 4 or 8 in spools and can be set up to weld with wire sizes .024 .035 in mild/stainless steel and .030 .045 in flux cored. Add the Spoolmate 3035 spool gun and SGA spool gun adapter for welding with .030 .035 in aluminum wire on 14 gauge to 1/4 in material.. Specifications: -MILLERMATIC 180 230V 60HZ 1PH.