Good for etching, thin block paper plate lithography printing. Student/beginner press. Best value in its grade. Instruction of using Etching Press: 1) Place the press on the newly included anti-slippery mash on table. Please note: There are four rectangular holes. You can also bolt down the press on the board. (Fastening bolt or devices not included.) 2) Attach the handle to the press. Make sure to place the tightening bolt on the Flat side of the metal stick so to avoid "slippery" when you crank the handle. 3) Place the metal plate and the felt between the two Rolling bars: One end starts between the bars, and the other end will rest on the supporting beam. (Leaving the metal plate on board -- below both rolling bars, the press can"t move the plate. 4) Lift the Felt and place inked art, and paper on the metal plate and cover them with the Felt. 5) Adjust the Two Pressure control handles to appropriate position. Make sure there is enough room between the two rolling bars to let the plate, felt and art work pass through yet with appropriate pressure to achieve a good print. 5) Crank the handle slowly and make sure the plate and art pass the bars smoothly.Please provide physical address for delivery of this item. Thanks.Please note this is an economic student and beginner grade press. Good for carry to class and do a simple demo. Be fair minded when you purchase this Press: if you expect this Press to give you same results as the professional Press, please don"t buy. Professional quality press sells for over $1000 or even $5000. Compare our price, even this same press is listed over $200 by other suppliers.Please contact us for appropriate assembly and usage instructions if you have any questions before you leave feedback. Thanks.