This single barre ballet bracket is manufactured by Easyway Manufacturing. The surface is powder coated with antique bronzed texture. It is fits aesthetically in any studio or home. All the corners are rounded to give a smooth and subtle appearance to blend into the surrounding. It is very sturdy and built with quality in mind. We offer 3 years warranty behind our work. This is the 2" bracket for the end of each barre. This listing is for ONE bracket only, You must have minimum of 2 brackets to support a barre. This bracket will fit wood rod that is approximately 1 3/8" in diameter. This is a very typical ballet barre diameter. Without being too technical, the wood rod is a standard closet pole that is readily available at Home Depot or Lowes for about $10 to $11 for a 8-foot long pole. We design this with a common sense. If you can easily go to Home Depot and get the wood rod at very good price, it does not make sense for us to sell you the wood rod at all! In general, if the wood rod span is up to 8 feet long, then 2 of this bracket is enough.If the wood rod span is 8 to 12 feet, we suggest using 3 brackets. (one on each end and one in the center.)Specification: ----Material: Tubular steel ----Surface finish: Antique copper textured scratch resistant powder coated paint. ----Lag Screws for wall mount are included -----Anchor Plate size: 9" H x 1 1/2" W x .7/32" T -----All holes are countersinked so no lag screw bolt head is protruded. -----Bracket extension from wall: 9"