This is the radio controlled, electric powered, DogFighter Airplane Kit from Multiplex. For intermediate to advanced fliers. FEATURES: Construction: Elapor foam Wing: One-piece, detachable for easy transport Aileron Control: Dual servo Spinner: Elapor foam, 2.5" (63.5mm) diameter, black in color Decals: Two sheets, "Racer" or "Fighter" designs INCLUDES: DogFighter Airplane Kit with Spinner, two Decal Sheets, Linkages, Hardware and Instruction Manual REQUIRES: Radio: 6-channel Servos: Three micro (2-aileron, 1-elevator) one for optional rudder control if desired Extensions: Two 6" (150mm) Motor: Brushless, Multiplex makes a Brushless Motor Power Pack (MPUM9250) that includes a Himax Outrunner Brushless Motor with Mounting Hardware, ESC and 10x7 prop specifically for this kit Note, if using this Power Pack, three 4mm Female Bullet Connectors (GPMM3119) must be soldered to the ESC motor leads to connect the ESC to the existing connectors on the motor Battery: 3S LiPo, at least 2200mAh Battery Charger: Comptible with selected battery Connector for ESC to mate with selected battery, see COMMENTS Field equipment SPECS: Wingspan: 35" (889mm) Wing Area: 296 sq in (19.12 sq dm) Wing Loading: 14.6oz/sq.ft (42.7g/sq.dm) Fuselage Length: 32" (813mm) Weight: 30oz (850.4g) Center of Gravity (CG): 2.7" (68mm) from the leading edge of the wing at the fuselage side Control Throws- Elevator, Up and Down: 0.27" (7mm) Rudder, Left and Right: 0.79" (20mm) Ailerons, Up 0.55" (14mm), Down 0.31" (8mm) COMMENTS: When using the recommended FlightPower LiPo battery, solder a Deans Male Ultra plug, WSDM1302 to the ESC. This connector will plug into the Ultra Female plug on the FlightPower battery. This model is NOT made of styrofoam and it is not possible to glue Elapor foam using white or epoxy glue. Medium CA glue used with an activator is the only method of gluing recommended by the manufacturer. jxs 09/28/11 ir/jxs