This is the radio controlled, brushless electric powered, Rx-Ready DG-1000 79" Scale Glider from ST Model. For thermal glider flyers 12 years of age and older. FEATURES: Construction: EPO foam, self aligning snap and lock construction Wings: Two-piece, high aspect ratio with lightweight wing tubes for strength without a lot of weight Aileron Control: Dual servo Motor: Brushless with RMS (retractable motor system), electronic mixer is controllable by throttle speed Servos: Four micro and one standard size Propeller: 7x5 (order MASQ1617 if replacement prop is needed) Canopy: Tinted Building Time: Ready to fly in under 1/2 hour INCLUDES: DG-1000 79" Scale Glider with propeller, motor, ESC, decals five servos, electronic mixer and instruction manual REQUIRES: Transmitter: 6-channel with 6-channel receiver, see COMMENTS Motor Battery: 3s 11.1V LiPo Deans Male Ultra Connector: WSDM1302 required if using above battery (cut existing connector off ESC and solder the Deans Ultra Male connector on the ESC Charger: LiPo compatible, such as the ElectriFly PolyCharge DC Charger (GPMM3010) To use this charger with the ElectriFly battery listed above, the Equinox Cell Balancer (GPMM3160) must be used, remove the red 2-pin plug on the battery and install 4mm female bullet connectors (GPMM3115) Building and field equipment SPECS: Length: 38.2" (970mm) Wingspan: 79.1" (2010mm) Flying Weight: 36.5oz (750g) Wing Area: 348.7 sq in (22.5 sq dm) Wing Loading: 10.9 oz/sq ft (33.3 g/sq dm) Center of Gravity (CG): 2.1" (53mm) behind leading edge of wing when the RMS is completely folded Control Throws: Aileron Up/Down: 10° Rudder Left/Right: 20° Elevator Up/Down: 15° COMMENTS: Included instructions for the Retractable Motor System (RMS) in the DG-1000 are illustrated using a Futaba T6EXAP in [1]Mode 1[IMAGE]. Please note that in [2]Mode 2[IMAGE], the throttle (CH 3) is on the left stick. Stated trim positions and EPA settings are specific to this transmitter. Since all transmitters from varying manufacturers may have different channel assignments, curves, and endpoint settings, you will have to adapt the instructions for your specific radio system. The transmitter pictured on page 3 of the manual is not included and must be purchaed separately. jxs 04/12/10 ir/jxs updt jxs 05/21/10 1. # 2. #