*NEW* Clarke USA 130EN MIG/Fluxcore Wire Welder KIT plus regulator kit, helmet, welding gloves, and welding cart (110V)This NEW in factory sealed box Clarke 130EN MIG/Fluxcore Wire Feed Welder KIT is easily converted from Fluxcore to Gas welding with the new Clarke gas regulator kit that comes with this and will weld up to 1/4" inch steel in a single pass! New welder comes with gas regulator kit, welding cart, welding helmet, welding gloves, roll of wire, chipping hammer/brush, and manual as well! Features Tweco-style torch with full On/Off Safetly Control. Electronic wire speed control and 4 variable heat settings allow you to precisely adjust the welder to your needs. Operates on standard 110 volt electrical supply. 120 V Wire Welder Tweco-style torch with full On/Off Safety control Advanced safety overload protection for transformer Electronic variable wire feed control 4 power settings for maximum welding heat control Welds steel, stainless steel, aluminum, or cast iron Fan cooled for better performance Welds up to 1/4" in a single pass Uses Fluxcore or solid steel welding wire Welds with or without gas Tough metal casing 200 Amp ground clamp CSA approved Input: 120V, 60 Hz, 13A, 1 Ph Ouput: 60A @ 21VDC - 40% MAX O.C.V. = 30 VDC MAX 85A